Plate Nº 96 · recorded November 16, 2026
Earth & ClimateReported finding
Adding Wind to Solar and Batteries Cuts Costs by Nearly a Fifth
An Ember analysis finds that pairing wind with solar and batteries lowers the median cost of meeting 90% of electricity demand from $105 to $86/MWh globally.
By Marcus Bennett4 min read820 words
In brief
- Adding wind to solar and batteries lowers the global median cost of meeting 90% of demand from $105/MWh to $86/MWh.
- The global cost reduction is nearly one-fifth, while northern regions see a two-fifths reduction.
- Bad weeks for solar and wind coincide about once every four years, Ember found.

Adding wind to a mix of solar power and batteries lowers the median cost of meeting 90% of electricity demand from $105 to $86 per megawatt-hour (MWh), a reduction of nearly one-fifth, according to Ember’s new analysis. A November 2026 Ember analysis also estimates a larger saving of two-fifths in northern regions.
What did the analysis measure?
Ember examined the median cost of reaching 90% uptime with a combination of solar, wind and batteries. Uptime means the share of time a system is available; the published summary also frames the target as meeting 90% of electricity demand.
The median means the middle result across the cases considered, not the cheapest or most expensive case. On that measure, the global cost falls from $105/MWh to $86/MWh when the analysis adds wind to the solar-and-battery mix.
Daan Walter, principal at Ember, framed the practical question: “We already know that solar and wind are cheap. The much more interesting question is how cheaply we can make them reliable.”
Walter continued: “And the answer is increasingly clear: by combining solar, wind and batteries, we can deliver reliable power at remarkably low costs almost everywhere in the world. That’s a pretty fundamental shift in the economics of energy.”
His conclusion rests on treating reliability as a property of the combined system, not of any single technology.
In short, the analysis values wind mainly for what it adds to solar and storage.
Why does a mixed system cost less?
The savings arise because solar and wind follow different daily and seasonal cycles. Solar output peaks when sunlight is strongest, while wind output can strengthen at other times. Combining them smooths the overall supply and makes it more dependable.
That variability also reduces how much battery capacity the system must hold in reserve. Batteries still have to cover periods when both sources underperform, but they no longer have to bridge every low-output period on their own.
Ember therefore treats wind as more than an additional source of electricity. It changes the amount and timing of storage required, which lowers the combined cost.
In plain terms, wind covers some gaps that would otherwise make solar run on larger batteries.
Where does wind add the most value?
Ember found the clearest gains away from the equator, including Europe. In its graph of annual output, wind and solar have almost opposite peaks and troughs: wind delivers most where solar delivers least.
That pattern means a region receiving strong summer sunlight may still obtain substantial electricity from wind when solar output falls. The mismatch between their seasonal peaks makes the two resources complementary rather than redundant.
Ember reports that adding wind cuts costs by two-fifths in northern regions, compared with nearly one-fifth globally. The summary provides no separate cost figure for Europe, so the regional result should not be read as a precise European price.
The farther north the system sits, the more wind can offset weaker solar periods.
Does the result hold during poor weather?
Ember tested the combination against variable weather rather than relying only on typical conditions. Its analysis found that bad weeks for solar and wind rarely coincide: the estimated frequency is about once every four years.
That does not mean one source always performs well, nor does it remove every period of weak output. It means that, in the cases examined, a prolonged simultaneous shortfall for both technologies was uncommon.
The relative independence of their weak periods gives the combined supply more stability and reduces pressure on batteries. Ember described the combination as a stable energy source within a volatile climate.
In practical terms, wind provides a second chance when a solar-rich region enters a poor week.
What should power planners take from this?
Ember’s figures point to a change in how planners compare options. Instead of choosing between solar, wind and batteries as stand-alone resources, the analysis asks what the three deliver together when the system must meet 90% of demand.
For practitioners, that changes the design question. The relevant calculation includes the cost of extra battery capacity caused by solar’s gaps, as well as the cost of wind and the value of its output during those gaps.
The finding does not make batteries optional. Storage still protects the combined system when renewable output falls, and the analysis does not supply a cost breakdown for every country, site or configuration.
Readers should also distinguish the global and northern figures from a universal price guarantee. The published figures do not cover every location equally, so project teams still need to match the result to local wind, sunlight and storage conditions.
The lesson for project teams is to price the whole system, not each power source in isolation.
The central takeaway is simple: combining solar, wind and batteries can lower the cost of reliability, although storage remains part of the system.
via energylivenews.com (Source)
More from Marcus Bennett
Show full bio
News editor covering regulation, policy and their impact on general science news at SciBeat.
442 articles